I have this Affinity front load washer that will not spin. I checked the service manual and ran the diagnostics test #6. When it completed it showed error E47. The manual instructions were to verify the door was closed, it was. Then it said to check the voltage on the J2 plug on the control panel. It's not labeled, but I think this is the White 2-wire plug which is right next to the Green 2-wire plug on the left side of the Control Board.

Mastering Adobe Photoshop Elements 4.0 on this page. The manual said to measure the Black wire to ground with the power on and if it's 120V I need to replace the Control Board. I measured it and it is 120V. I just wanted to check to see if this is accurate before I spend the cash on the Control Board. I've seen other posts in this forum where the Door Lock assembly was the problem and much less expensive than the Control Board. Are there any other tests that I can perform to determine which part I need?

Thanks, John. The Door Lock Assembly arrived yesterday and it fixed the problem. So the troubleshooting guide in the manual was a bit misleading suggesting the Control Board. Incidentally, I measured resistance on the defective switch at the top of the Door Lock Assembly and was getting various readings from 1500 ohms to 1800 ohms. On the new switch I was getting a steady reading of about 800 ohms. I installed the new switch by removing the wire that holds the door seal in place and removing the door seal in the area of the Door Lock Assembly. This is much easier than accessing it through the top of the washer.